Description: Soudabond easy is a gun applied ready to use single component self expanding polyurethane adhesive. The product has been developed for clean, efficient, economic and permanent bonding of insulation panels and lightweight decorative elements in wall and roof areas. Applications: • Bonding of various types of insulation panels onto roofs, walls and façades. • Bonding of decorative elements in façade applications. • Filling of cavities between insulation panels. Properties Base Single component Polyurethane Consistency Stable Adhesive Foam – does not sag Curing System Moisture Cure at room temperature Skin Formation +/- 8 minutes (20°C/65% R.H.) Can be trimmed +/- 40 minutes – 30mm adhesive bead Drying time Dust free after ca 9 min. – 30mm adhesive bead Full strength +/- 12 hours – 30mm adhesive bead Post expansion Minimal Heat Transmission (DIN 52612) About 0,036 W/(m·K) Tear Strength (DIN EN 1607) 0,18 N/mm² Shear Strength (DIN 53427) 0,12 N/mm² Resistance to bending (DIN5342) 0,6 N/mm² Resistance to pressure (ISO844) 0,3 N/mm² Elongation at break About 25% Water absorption (DIN53428) < 1% Shrink < 3% Fire Rating B2 (normal flammability) Temperature Resistance -40°C until +90°C when cured +120°C (until maximum 1 hour) Yield +/- 12m² per can of 750ml – 30mm adhesive bead Characteristics: • Saving of up to 30% in working time. • Very good initial bond, even at low temperatures. • Economic in use due to precise application – sufficient for 12m² of roof insulation panels (3 beads per m²). • Suitable for vertical and horizontal applications. • Can be applied at temperatures as low as -5°C (temperature of aerosol can needs to be at least +5°C). • Excellent insulation characteristics, enhances performance of insulation panels when filling gaps (ca 0,036 W/(m·K). • Remains flexible, does not become brittle. • Suitable for uneven surfaces as it fills cavities. • Limited post expansion, resulting in fast and precise installation of insulation panels. • Very wide adhesion spectrum: various types of boards such as plasterboard and dry lining, roofing, concrete, stone, brick, timber, various insulation panels and decorative elements based on PU, Polystyrene, Phenol resin foam, etc. • Compared to usual types of PU Roof adhesives and Dry lining or plasterboard adhesives, huge savings in space and weight. • Fast curing; 1 hour after application work can continue on flat roofs or boards can be plastered • Free of CFC’s and HCFC’s. Propellant gas does not damage ozone layer. • Free of solvents. • Compatible with most types of paints, many solvents and chemical substrates. • Does not age or rot, but should not be exposed to UV radiation (cover with paint or plaster if necessary).